User's Manual

20
3.4 Configuration
For parameter configuration, device bind is required. “Bind” is used to pair an
air unit with ground unit. To pair an air unit and an ground unit,
1. Connect the air and ground devices.
2. Press the bind button of the air device.
3. Press the bind button of the ground device.
4. Power off both units for at least 10 seconds.
5. Power on both units. If the two units are not binded, “unbind” is shown
under “BIND” status in Ground Status section. If the two units are binded,
“binded” is shown under “BIND” status in Ground Status section.