Owner`s manual

6
Ayon Audio – Hart 18 – 8101 Gratkorn – Austria – Phone: [phone]
www.ayonaudio.com
KT88
KT88
1Pins
1st pin
in all 8 pins
ECC82
12AU7
in all 9 pins
the tubes
2. Connecting
To assure reliable operation always turn the Orion OFF while making or changing input or
speaker connections. No connections should be made while the amplifier is ON.
R e a r p a n e l
All input and output connectors are clearly marked on the rear panel
LOUDSPEAKER: There are three sets of gold speaker output terminals at the rear panel: Left out,
common, 4, 8, ohm, Right out, common, 4, 8, ohm. Connect the speaker input terminals to
corresponding speaker output terminals at the rear panel according to the impedance of the
speaker with high quality audio cord. Pay close attention to proper matching of positive and
negative and left and right channels.
a.) INPUT: LINE1, LINE2, LINE3, connect your device with a high quality RCA lead.
You can then select any source input for LINE1, LINE2 & LINE3.
Rotate input selector accordingly.
b.) USB: Connect a computer or digital source etc. to this input.
c.) The Orion is also equipped with a source output (Pre-Out), an output for connection to a
sub-woofer or other device.
d.) TP: Test points for bias.
e.) Bias: Regulation of static working point bias current.