Owner`s manual

7
Ayon Audio – Hart 18 – 8101 Gratkorn – Austria – Phone: [phone]
www.ayonaudio.com
Common4 Ohm
TP 4
Bias 4
Source
Right
Left
USB
8 Ohm TP 3
Bias 3
TP 2
Bias 2
TP 1
Bias 1
Line 3Line 2Line 1
Serial No. 0
Ayon - Austria ayonaudio.com
Phase
~AC In
Pre Out
Power
rear panel
（1）source input (3x line & USB) and source output (Pre out)
（2）speaker out ( Common, 4 Ohm or 8 Ohm )
（3）potentiometer for bias adjustment
（4）test point for bias check
（5）power inlet - with fuse
（6）power switch
（7）phase indicating lamp – 230V Schuko only
The power connection is located at the rear panel. Plug the AC power cord into receptacle.
Power switch off = “0” - Power switch on = “|”.
It is recommended that you do not use a power conditioner as it may limit the current
available to the amplifier.
Note: When the phase control indicator glows red the Phase polarity is wrong. Reverse the AC
plug! (This function applies for 230V and Schuko plug version only)
3. Turn ON procedure
When all sources are connected properly, turn down the volume to minimum, switch on the
power, it will go through a gentle power-on sequence first.
Please wait for min. 60 seconds before turning the volume up. After 60 seconds, the unit is
operational. Now you can increase the volume via the volume control.
Follow this procedure each time you turn your Orion on.
Some sources can generate dangerous transients that can damage loudspeakers. To avoid
letting dangerous transients reach your loudspeakers turn your system on in the following order:
1) Turn on all sources (CD, tuner, etc.) that you will be using.
2) Power up Orion amplifier.
3) Select listening source and play music.