Owner`s manual

6
Ayon Audio – Hart 18 – 8101 Gratkorn – Austria – Phone: [phone]
www.ayonaudio.com
OPERATION
1. Installing the vacuum tubes
Please remove the vacuum tubes and the Typhon from box and place the Typhon on a firm,
level surface. Insert the vacuum tubes in accordance with the designated tube numbers into
their relative assigned sockets. Note: It is very important to insert the tubes in the correct
location. Important: Pay close attention to the direction of socket pins and their different
diameter (6C33) of pins. If the direction is wrong and you force the tube, damage to the socket
pins will occur. NEVER FORCE A VACUUM TUBE INTO PLACE. Tube should glide right in and have
to fit tighten (good pin contact). Ensure that all of the tubes are fully seated in their sockets.
the tubes
2. Connecting
To assure reliable operation always turn the Typhon OFF while making or changing input or
speaker connections. No connections should be made while the amplifier is ON.
R e a r p a n e l
All input and output connectors are clearly marked on the rear panel.
SPEAKER CONNECTION: There are three sets of gold speaker output terminals at the rear panel:
common, 4 ohm and 8 ohm. Connect the speaker input terminals to corresponding speaker
output terminals at the rear panel according to the impedance of the speaker with high quality
audio cord. Pay close attention to proper matching of positive and negative and left and right
channels.
INPUT CONNECTION:
Select RCA or XLR input to connect your preamp and set toggle switch
accordingly