Owner`s manual

7
Ayon Audio – Hart 18 – 8101 Gratkorn – Austria – Phone: [phone]
www.ayonaudio.com
rear panel
1 input ( RCA or XLR )
2 speaker output terminal ( common , 4 Ohm or 8 Ohm )
3 potentiometer for bias adjustment: Bias 1 & Bias 4
4 bias meter selector ( Off, V1, V2, V3, V4 )
5 potentiometer for bias adjustment: Bias 2 & Bias 3
6 power inlet - with fuse
7 toggle switch for RCA or Balanced mode
8 phase indicating lamp - 230V Schuko only
9 ground switch
bottom plate
Note: The power switch (on/off) is located at the front left corner of the bottom plate. Plug the
AC power cord into receptacle. Power switch off = “0” - Power switch on = “|”.
It is recommended that you do not use a power conditioner or re-generator as it may limit the
current available to the amplifier.
Note: When the phase control indicator glows red the Phase polarity is wrong. Reverse the AC
plug! (This function applies for 230V and Schuko plug version only)