RGBW LED beam movinghead User manual 1
Safety precautions WARNING: This unit may cause serious injury to the eyes when used incorrectly. It is therefore strongly advised to read this user manual carefully, to get familiance yourself with the functions of this device. WARNING: This unit must be operated by, or under the supervision of an adult. This device is not suitable for children. WARNING: Do not look directly into the beam from a short distance. This may cause serious injury to the eyes.
Box contents Box contents 1x ERO 3108 movinghead 1x power cable 1x XLR-XLR signal cable 1x installing bracket 1x safety cable Unit and accessory inspection - Always use the supplied power cable to connect the unit to a power supply. If the cable appears broken or has visible damage, do not use it. - If the unit is not going to be used for a longer period of time, disconnect it from the power supply and store it in a dust-free environment. - Always check the unit for possible damage before use.
Device overview 1. Beam output 2. Control panel with display and menu-functions 3. On/off switch 4. Fuse 5. Power input (Twist-lock connector) 6. DMX input 7. DMX output 8.
Setting up the unit To activate the unit, connect the included power supply to the unit and a suitable 230V, 50 Hz power outlet. Switch the on/off switch to the βONβ position, the LED movinghead will activate. Give the movinghead time to calibrate the stepping motors, which are used to determine the position of the head. You may hear and see some shaking, which is normal. The stepping motors use an end point to determine the beginning and end of their movement.
The ERO 3108 is equipped with several working modes, each with its own advantages. For simple events there are stand-alone modes, for advanced situations there are options to create synchronized lightshows, or controlled with a DMX-512 controller. A short description for each mode can be found below: Auto: Automatic lightshow with a pre-programmed internal show, on a pre-defined speed.
Channel 1 2 3 4 Function Pan Tilt Dimmer Strobe 5 6 7 8 9 10 Red Green Blue White Motor speed RGB macro function 11 Auto 12 Reset Value 0-255 0-255 0-255 0-6 7-65 66-69 70-128 129-132 133-191 192-195 296-255 0-255 0-255 0-255 0-255 0-255 0-4 5-44 45-49 50-94 95-99 100-149 150-154 155-166 167-178 179-190 191-202 203-214 215-226 227-238 239-250 251-255 0-127 128-255 0-250 251-255 Description Pan movement 8-bit Tilt movement 8-bit Dimmer function 0-100% No function Strobe function Slow β Fast No funct
Installation and maintenance Mounting the bracket The included omega-type bracket is designed for this movinghead and makes it easy to mount en remove a mounting hook to your fixture. A G-clamp, halfcoupler or triggercoupler can be mounted to the omega bracket, which on his turn can be mounted to the fixture with quick-lock fastners. With a clockwise rotation of 90 degrees, the omega-type bracket is mounted to the fixture.
Clean the fan outlet and the cooling vents with a small brush, while using vacuum cleaner suction to remove any loose dust and/or dirt. Clean the exterior of this fixture once a month. When using this fixture intensively, the frequency of maintenance needs to be increased. Transport When using this fixture in mobile setups, provide sufficient protection during transport. Use the original packaging of this unit, or use a professional flightcase with proper foam inlay.
Technical specifications - RGBW LED beam movinghead - 108x 3 Watt high power Edison LEDs, spread over red (24), green (28), blue (28) and white (28) - expected lifespan LEDs: 50.