Owner manual

To enter the advanced setup mode, make sure that

the amplifier is in the low-current consumption

state (green LED illuminated on the right-hand

button). Then press and hold the left-hand button

for three seconds. This enters the unit into the basic

setup mode. The display will briefly show

“

SET UP” and then display “XXX 1” where

“XXX” is the name assigned to input 1.

Use the right-hand knob to select which input

(

1 - 6) you wish to configure with advanced options.

Then briefly press the right-hand button to enter

the advanced menu level. The left-hand knob will

select which setting you wish to configure for that

input:

• CN - Custom Name

• GOS - Gain Offset

• PP - Processor Pass-Through

• AL - AyreLink

• RST - Reset

After you have selected the desired choice, press the

right-hand button to enter the selection.

XXX 1

SET UP

GOS

RST