OUTDOOR FIRE PIT MODEL # FPS-DGH FPS-DGHSS R R R C US ANS Z 21.97-2010, Outdoor Decorative Gas Appliances CGA CR 97-003 Outdoor Gas Fireplaces Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-888-775-1330, 7 a.m. - 4 p.m., PST, Monday - Friday.
PACKAGE CONTENTS A B C D G E H F J I K L PART A B C D E F G H I J K L 2 DESCRIPTION Cover Burner Assembly 1/4 Table Angle Iron Back Bracket Post (Left) Front Bracket Post (Left) Back Bracket Post (Right) Front Bracket Post (Right) Side Panel Gas Cylinder Block Belt Bottom plate Door QUANTITY 1 1 4 4 1 1 1 1 3 1 1 1
HARDWARE CONTENTS AA Screw M4 X 25 Qty. 1 DD CC BB Screw M4 X 8 Qty. 1 M6 nut Qty. 8 Bolt M6 X 30 Qty. 4 GG HH Wrench Qty. 1 Propane Tank Strap Qty. 1 II Glass (One Pack) Qty. 1 EE FF Bolt M6 X 12 Qty. 42 Screw M5 X 8 Qty. 4 JJ Knob Qty. 2 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. This appliance has been tested to and complies with the CSA INTERNATIONAL REQUIREMENT 4.96 FOR OUTDOOR GAS FIREPLACES.
SAFETY INFORMATION DANGER DANGER • EXPLOSION - FIRE HAZARD • Keep solid combustibles, such as building materials, paper or cardboard, a safe distance away from the fire pit as recommended by the instructions. • Provide adequate clearances around air openings into the combustion chamber. • Never use the fire pit in spaces which do or may contain volatile or airborne combustibles, or products such as gasoline, solvents, paint thinner, dust particles or unknown chemicals.
SAFETY INFORMATION WARNING WARNING California Proposition 65 Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other reproductive harm. • This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone.
ASSEMBLY INSTRUCTIONS 1. Screw the knob (JJ) on the door (L) with M4 X 25 screws (AA). 1 L M Hardware Used AA Screw M4 X 25 JJ Knob x1 x1 2. Attach an angle iron (D) to 1/4 table (C) with M6 X 12 bolt (EE). Repeat procedure to complete the assembly of the rest of three 1/4 tables. D C Hardware Used EE Bolt M6 X 12 2 x4 3. Line up holes in 1/4 table with corresponding holes the other 1/4 table, insert two M6 X 12 bolts (EE) through holes, finger tighten two M6 nuts (DD) .
ASSEMBLY INSTRUCTIONS 4. Attach propane tank strap (HH) to bottom plate (L) as shown in figure 4. 4 Hardware Used HH Propane tank strap x1 x1 5. Bracket Post Installation. 5-1. Attach four bracket posts to the bottom plate with four M6 X 30 bolts (CC) as shown in figure 5-1. L 5-1 E F Hardware Used CC Bolt M6 X 30 x4 5-2. Assemble the bracket posts and gas cylinder block belt (J ) with two M6 X 12 bolts as shown in figure 5-2.
ASSEMBLY INSTRUCTIONS 6. Door Installation. 6-1. Attach door as shown in figure 6-1. 6-1 L 6-2. Put door above front bracket post (left), fasten the door bracket with four M6 X 12 bolts. 6-2 Hardware Used EE Bolt M6 X 12 x4 7. Side panel (I ) Installation. 7-1. Attach three side panels to the bracket posts with 12 M6 X 12 bolts.
ASSEMBLY INSTRUCTIONS 7-2. After assembly, the base assembly will look like figure 7-2. 7-2 8. Table Installation 8-1.Line up holes in assembled table with corresponding holes in base assembly, insert eight M6 X 12 bolts through holes and tighen. 8-1 Hardware Used EE Bolt M6 X 12 x8 8-2. After assembly, the fire pit will look like figure 8-2.
ASSEMBLY INSTRUCTIONS 9. Burner Installation 9-1. Line up holes in the burner assembly (B) with corresponding holes in the table assembly, insert four M5X8 screws (FF) through holes, tighten. 9-1 B Hardware Used FF Screw M5X8 x4 9-2.The total assembled parts will look like figure 9-2. 9-2 10-1 Screw the knob (JJ) to the cover (A) with M4 X 8 screws (BB). Pour lava glass (one pack) (II) into the burner and put the cover above the burner assembly.
ASSEMBLY INSTRUCTIONS 10-2. Total fire pit assembly is complete. 10-2 11. Connect hose and regulator to cylinder. The propane gas and cylinder are sold separately. Use a standard 20 lb. propane cylinder only. Use this heater only with a propane vapor withdrawal supply system. See chapter 5 of the standard for storage and handling of liquefied petroleum gas, ANS/NFPA 58. Your local library or fire department should have this book.
ASSEMBLY INSTRUCTIONS A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder supplier. Never use a propane cylinder with a damaged valve connection. The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders, spheres and tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
OPERATION INSTRUCTIONS Leak Check WARNING • Perform all leak tests outdoors. • Extinguish all open flames. • NEVER leak test when smoking. • Do not use the fire pit until all connections have been leak tested and do not leak. Hose / Regulator connection Regulator / Cylinder connection 1. Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops of solution where hose attaches to regulator. 3.
OPERATION INSTRUCTIONS DANGER • CARBON MONOXIDE HAZARD • For outdoor use only. Never use inside house, or other unventilated or enclosed areas. This fire pit consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life. Caution: Do not attempt to operate until you have read and understand all General Safety Information in this manual and all assembly is complete and leak checks have been performed. Before Turning Gas Supply ON: 1.
OPERATION INSTRUCTIONS WARNING FOR YOUR SAFETY Be careful when attempting to manually ignite this fire pit. Holding in the control knob for more than 10 seconds before igniting the gas will cause a ball of flame upon ignition. When fire pit is ON: Burner will display tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with straight yellow tops.
OPERATION INSTRUCTIONS 9. Fire pit is away from gasoline or other flammable liquids or vapors. 10. Fire pit is away from windows, air intake openings, sprinklers and other water sources. 11. Fire pit is at least 24 in. on rear and at least 24 in. on sides from combustible materials. 12. Fire pit is on a hard and level surface. 13. There are no signs of spider or insect nests. 14. All burner passages are clear. 15. All air circulation passages are clear. 16.
CARE AND MAINTENANCE Gas odor with extreme yellow tipping of flame. Fire pit does NOT reach the desired temperature. Fire pit glow is excessively uneven. Fire pit makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire pit and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles. Carbon deposits may create a fire hazard.
TROUBLESHOOTING If you have any questions regarding the product, please call customer service at 1-888-775-1330, 7 a.m. - 4 p.m. (PST), Monday - Friday.
ONE-YEAR LIMITED WARRANTY CUSTOMERS IN USA Do not return this product to the store where you purchased it. Please call 1-888-775-1330 for assistance. CUSTOMERS IN CANADA IMPORTANT Only return this product to the store if it was purchased within 90 days. If you have problems after 90 days of purchase, please CALL 1-888-775-1330 DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE. This product is inspected, tested and carefully packaged to minimize the chance of damage during shipment.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-888-775-1330, 7 a.m. - 4 p.m., EST, Monday - Friday.