Use and Care Manual

ASSEMBLY INSTRUCTIONS
12 13
9. Use Phillips screwdriver (OO) to install
side panels (J) to bottom of assembly
with M5 x 12 mm screws (DD).
Note: Do not cover the panel where the
control knob is.
10. Using Phillips screwdriver (OO),
assemble the chain (LL) and wafer (KK) to
the inside of font panel (O) with M4 x 10 mm
screw (MM) and M4 nut (JJ).
Then install
knob (II) to M4 x 10 mm screw (MM) on front
panel (O). Hang the chain (LL) from the hole
on control box assembly (I) and place the
pothooks on bottom of front panel (O) onto
the holes of the bottom plate (N).
9
10
Hardware Used
Knob
x 1
II
x 1
JJ
Wafer
x 1
KK
Chain
x 1
LL
M4 Nut
Hardware Used
M5 x 12 mm Screw
x 8
DD
Philips
Screwdriver
x 1
OO
J
DD
LL
I
KK
MM
II
GG
O
N
M4 x 10mm Screw
x 1
MM
Phillips
Screwdriver
x 1
OO
ASSEMBLY INSTRUCTIONS
7. Carefully install the glass tube (G)
between the center of top plate (D) and
control box assembly (I). Make sure the
end of the glass tube (G) is inserted securely
into the three clips of the control box
assembly (I).
8. Carefully lean the assembly down so you
can install studs (CC) to top plate (D),
securing the studs (CC) with M8 cap nuts
(HH). Assemble the mesh (B) to the studs
(CC) with M8 nuts (GG). Secure the mesh (B)
to the mesh base (C) with M5 x 12 mm
screws (DD).
7
8
Hardware Used
Stud
x 3
CC
x 3
DD
M8 Nut
x 3
GG
M8 Cap Nut
x 3
HH
M5 x 12 mm Screw
D
G
I
CC
HH
DD
GG
c
D
B