User Guide

The LIST Command
The LIST command allows a user to list all available commands for the current mode.
Command Syntax Command Mode Purpose
List command All modes The LIST command lists all
commands that may be
entered in the current mode.
The following are examples of using the list command:
MSR2000(config)# interface fast-ethernet 0
MSR2000(config-if-ethernet)# list
end
exit
help
interface fast-ethernet <0-1>
ip address A.B.C.D/M
ip address dhcp
list
mode access
mode gateway
mode gateway A.B.C.D
mtu <256-1500>
no ip address
no mode access
no mode gateway
no mtu
no shutdown
quit
show running-config
shutdown
write file
write memory
write terminal
Figure 2 list Command Examples
CLI Navigation
To assist with navigation as you move among the CLI modes, the prompt changes to
indicate the mode. Table 1 lists the CLI mode, its corresponding prompt, and information
on how to access and exit this CLI mode.
Table 1 CLI Mode Information
CLI Command
Mode
Pro
mpt To Enter Mode To Exit mode
User EXEC MSR2000> Access the router through Telnet
and successfully log in
User the exit
commands.
Privileged EXEC MSR2000# From the EXEC mode, use the
enable command.
From any other mode, use the
end command.
Use the either the exit
command.
CONFIGURATION MSR2000(config)# From the Privileged EXEC mode,
use the configure terminal
Use the either the exit or
end command.
MSR2000 CLI Configuration Guide
10