User Guide

Deleting Command Lines in the Configuration File

Each command enters a command line in the Azalea MSR2000 running configuration

file and the “no” form of the command removes the command line form the running

configuration file. To disable a command, use the “no” form of that command. The

majority of the commands in Azalea CLI have a “no” command that disables the

command or re-enable a disabled function. For example, to delete a static route, use the

no ip route <IP destination prefix> <Gateway IP address> command syntax. For both

the command syntax and the “no” syntax, refer to CLI Command Line Interface

Reference.

Table 2 CLI Mode Information (no command)

MSR2000(config)# no ip route 10.2.2.0/24 10.1.1.1

MSR2000 CLI Configuration Guide