User Guide

Use any of the following commands to display information about the configuration file:
Table 8 Display running configuration and startup configuration
Command Syntax Command Mode Purpose
show startup-config Privileged EXEC Displays the configuration information
stored in the internal memory.
show running-config Privileged EXEC Displays current configuration
information on the system.
Setting CONFIGURATION Mode Parameters
The configure command places you in the CONFIGURATION mode where you can configure
interfaces and routing protocols.
From the CONFIGURATION mode, enter any of the following commands to configure protocols
or interfaces:
Table 9 Enter CONFIGURATION mode
Command Syntax Command Mode Purpose
show startup-config CONFIGURATION Display the configuration information
stored in the internal memory
node-id CONFIGURATION Set node ID, should be value between 1
and 255.
router-id CONFIGURATION Set router ID
A.B.C.D The ip address to be the
loopback id of the router
Interface <interface> CONFIGURATION Configure a physical or logical interface
on MSR2000.
1.) dot11radio
2.) fast-ethernet
show running-config CONFIGURATION Display current configuration information
on the system.
MSR2000 CLI Configuration Guide
17