User Guide

only have one radio in client mode.
Common settings
Radio Interface supports two type of hard-ware mode: 802.11a and 802.11g (backward-
compatible with 802.11b) and each mode is associated with country codes and specific
radio channels. The channel settings on the wireless device correspond to the
frequencies available in the regulatory domain.
The following table outlines the physical, layer-2 settings that may configured on each
radio interface. These settings apply in both access and backhaul modes.
Command Syntax Command Mode Purpose
wireless-mode <mode>
<channel> [country code]
INTERFACE
DOT11RADIO
Configure the physical wireless settings of
this radio interface.
mode: a or g
a: Use 802.11a
g: Use 802.11b/g
channel: Mode and country-specific
channel number
Mode g and US: 1-11
Mode g and JP: 1-14;
Mode g and CN: 1-13;
Mode a and US: 149, 153, 157, 161, 165;
Mode a and JP: 36, 40, 44, 48
Mode a and CN: 149, 153, 157, 161, 165
country-code: US, CN, or JP
US: United States
CN: P.R. China
JP: Japan
shutdown
no shutdown
INTERFACE
DOT11RADIO
Administratively shutdown this radio; all
existing operations on this radio will stop
Activate the interface
antenna <0-2>
antenna 0
no antenna
antenna 1
antenna 2
INTERFACE
DOT11RADIO
Configure this radio interface to use one of
the two antennas connected to the physical
radio card
Automatically choose the best antenna
(default)
Always use antenna 1
Always use antenna 2
MSR2000 CLI Configuration Guide
22