User Guide

Chapter 6 Client Mode Configuration
When a Dot11Radio interface is configured for client mode, an 802.11 client station
configured under that interface can associate to any matching 802.11 access points as
any other 802.11 client. The access point can be BSSs provided by other MSR2000s or
an AP from other vendors. On each MSR2000 router, only one radio interface can
operate in client mode and have station configured.
Basic Client Mode configuration
The following table outlines the basic settings for a client station
Table 15 Configuring Basic Client Mode
Command Syntax Command
Mode
Purpose
station <station name>
no station <station name>
INTERFACE
DOT11RADIO
Configure a 802.11 client station
on this radio interface
Remove 802.11 client station
setting from this radio interface
ip address [ip address/mask]
ip address dhcp
no ip address
INTERFACE
DOT11RADIO
STATION
Set IP address of this client
station.
Set IP address to be
automatically obtained by using
the DHCP protocol; a DHCP
server must be running on the
network this station associates
to.
Remove IP address from this
client station.
authentication-algorithm open
authentication-algorithm shared-key
INTERFACE
DOT11RADIO
STATION
Configure authentication
algorithm as open (default)
Configure authentication
algorithm as shared key
wep-key <1 | 2 | 3 | 4> <key-string>
no wep-key <1 | 2 | 3 | 4 >
wep-default-key <1 | 2 | 3 | 4>
no wep-default-key
INTERFACE
DOT11RADIO
STATION
Add a WEP key to the client
station
Remove a WEP key from the
client station
Specify the key index for default
WEP key to use at transmission
(default is WEP key 1)
Remove default WEP key
configuration
MSR2000 CLI Configuration Guide
35