User Guide

scanning threshold rssi <rssi value>
no scanning threshold rssi
INTERFACE
DOT11RADIO
STATION
Configure the RSSI value
threshold to trigger a new scan.
If the current RSSI is lower than
configured threshold, the client
will start a new scan.
<rssi value>: a number between
0 and 100. 0 means no such
trigger. Default value is 15.
RSSI stands for Received
Signal Strength Index
Restore the default RSSI
threshold value.
release-dhcp dot11radio <0-1> station
<station name>
renew-dhcp dot11radio <0-1> station
<station name>
restart-dhcp dot11radio <0-1> station
<station name>
Privileged
EXEC
Release the station’s IP
address acquired from DHCP
server
Renew the station’s IP
address via DHCP server
Restart DHCP client for the
station
.
Viewing information of a station in a dot11radio interface.
MSR2000# show run
...
!
interface dot11radio 0
...
station demo
ip address dhcp
access-point ssid demo
scanning automatic
...
MSR2000# sh interface dot11radio 1 stations
Station test
State: Associated
Access Point SSID: AzaleaTest1
Access Point BSSID: 00:17:7b:18:18:40
Previous Access Point BSSID: NA
IP Address: 172.16.44.200(DHCP acquired)
WEP disabled
Automatic scanning: enabled
Scanning threshold: RSSI 15
Minimum scan interval: 60 seconds
scanning in hardware modes: ag
scanning in channels:
mode A: 36 40 44 48 52 56 60 64 149 153 157 161 165
mode G: 1 2 3 4 5 6 7 8 9 10 11
Figure 12 Output of station information under dot11radio interface
MSR2000 CLI Configuration Guide
38