User Guide

The link quality parameters monitored by RFM include RSSI, SNR, overall quality
15
, and
data rate.
RFM related configuration commands
The following table summarizes the commands used to configure RFM’s auto-discovery
and link monitoring functions:
Command Syntax Command Mode Purpose
wds auto
no wds auto
INTERFACE
DOT11RADIO
Enable automatic WDS provisioning
on this radio interface and enter the
INTERFACE DOT11RADIO WDS
AUTO mode for auto WDS
configuration; this command is
mutually exclusive with the wds <0-5>
command.
Disable auto WDS on this radio
interface.
max-auto-wds <1-6> INTERFACE
DOT11RADIO WDS
AUTO
Set the maximum number of auto
WDS interfaces that could be created
on this RFM
service rf-management CONFIGURATION Start the configuration of the RFM
service
enable SERVICE
RF-MANAGEMENT
Activate the RFM function
debug
debug none
debug error
debug state
debug information
debug frame
debug dump
SERVICE
RF-MANAGEMENT
Set the RFM debug log level
Disable RFM debug log
Set RFM debug log to record errors
Set RFM debug log to record errors &
state changes
Log error, state, and other detailed
information
Log error, state, information, and RFM
control packet frames
Log all RFM debug information
The following commands can be entered at the privileged EXEC prompt to display
information about the RFM service:
15
The link quality percentage measurement is based on the level of RFM control packet loss.
MSR2000 CLI Configuration Guide
40