User Guide

Both begin and end IP should be a valid
IPv4 unicast address.
Attaching DHCP pools to BSSs
Different BSSs may use different DHCP pools. You can use the following command in
the “BSS mode” to attach DHCP pool to BSSs:
Command Syntax Command Mode Purpose
dhcp server <POOL-NAME>
dhcp server automatic
no dhcp
INTERFACE
DOT11RADIO BSS
Attach a manual DHCP pool to the
current BSS
19
Attach an automatic DHCP pool to the
current BSS
Detach DHCP service from the
current BSS
Show DHCP Server Information and Status
You can use the following commands to show current configuration about DHCP server.
Table 19 Display DHCP Server Information
Command Syntax Command Mode Purpose
show dhcp server all Privileged EXEC Show all DHCP server
information
show dhcp server default-lease-time Privileged EXEC Show the current value of default
lease time
show dhcp server dns Privileged EXEC Show the current dns value
show dhcp server lease Privileged EXEC Show the current IP address
assignments
show dhcp server max-lease-time Privileged EXEC Show the current value of
maximal lease time
show dhcp server pool Privileged EXEC Show the current DHCP pools
Viewing DHCP Server configuration
!
! Configuration
!
router dhcp server
19
Only one of DHCP pool and DHCP relay can be used on a BSS, so if this BSS had DHCP relay enabled
(see next section), it will be disabled.
MSR2000 CLI Configuration Guide
53