User Guide

disable IP DHCP RELAY Temporarily stop the DHCP relay service
dhcp-servers
[SERVER-list]
no dhcp-servers
IP DHCP RELAY Configure a list of DHCP servers to
which the DHCP requests would be
relayed. Multiple servers may be
specified by separating them with
commas (,).
Clear the DHCP server list
Enabling DHCP Relay on specific BSSs
Not all BSSs have to use DHCP relay; some may use DHCP pools or no DHCP service
at all. You can use the following command in the “BSS mode” to enable DHCP relay for
a BSS:
Command Syntax Command Mode Purpose
dhcp relay
no dhcp
INTERFACE
DOT11RADIO BSS
Enable DHCP relay on this BSS
20
Disable DHCP service from the
current BSS
Show DHCP Relay Information
You can use the following commands to show current configuration about dhcp relay. Note that it
should be in ENABLE mode.
Table 21 Configuring DHCP Server
Command Syntax Command Mode Purpose
show dhcp relay dhcp-servers Privileged EXEC Show DHCP servers are used by
DHCP relay
Viewing DHCP Relay configuration
!
!DHCP Relay Configuration
!
router dhcp relay
dhcp-servers 192.168.1.1,192.168.1.2
!
!Display DHCP Relay Information
!
MSR2000# show dhcp relay dhcp-servers
dhcp-servers: 192.168.1.1 192.168.1.2
!
20
Only one of DHCP pool and DHCP relay can be used on a BSS, so if this BSS had DHCP pool attached
(see previous section), it will be removed.
MSR2000 CLI Configuration Guide
55