User's Manual
Table Of Contents
- 1 MSR4K44S Quick Installation Guide
- 2 Abstract
- 2.1 Function Introduction
- 2.2 Appearance and Interfaces
- 2.3 Operating Range
- 2.4 Environmental Rating
- 2.5 LED Panel
- 2.6 Ethernet Cable
- 2.7 Console Cable
- 2.8 Power Cable
- 2.9 Screws
- 3 Installation Preparation
- 4 Antenna Installation
- 5 MSR4K44S Installation
- 6 Lightning Protection Installation
- 7 Feeder Installation
- 8 Ethernet Cable Installation
- Power Cord Installation
- 10 Completed Installation
- 11 Administrating the MSR4K44S
- Appendix
AZALEA MSR4K44S INSTALLATION GUIDE
COPYRIGHT 2007 AZALEA NETWORKS
22
6 Lightning Protection Installation
The lightning protector is to protect MSR4K44S to avoid damage by burst high
current from lightning. Lightning protector should be installed between radio port
and antenna feeder, and the lightning protector should be connected with lightning
system of the building .
Tools needed: Paper knife, Pliers, Crimping Pliers, Cross Screwdriver, and Spanners.
The procedure of lightning protector:
1. Connect the lightning protector to radio port of MSR4K44S;
2. Fasten the lightning protector by Spanner;
3. Unpack the copper ring of grounding.
4. Put the naked side of grounding wire into copper ring and pressed firmly by
Crimping Pliers;
5. Connect the grounding copper ring with lightning protector and fasten it by
Cross Screwdriver;
6. Connect the another side of grounding wire with grounding bar;
7. Daub butter on both side of grounding wire;
Lightning
Protector