User`s guide

ManualsBrandsAzden ManualsMicrophones35XT

330 SYSTEM

User’s Guide

330UPR • 35BT • 35HT • 35XT

DUAL-CHANNEL ON-CAMERA

UHF WIRELESS MICROPHONE SYSTEM

1-12-17 Kamirenjaku Mitaka-shi Tokyo 181-8533 Japan

Tel :+81(0)422-55-5115 Fax :+81(0)422-55-0131

E-mail : sales@azden.co.jp URL http://www.azden.co.jp

Printed in Japan 060-35513-01

Summary of content (6 pages)

PAGE 1
330 SYSTEM User’s Guide 330UPR • 35BT • 35HT • 35XT DUAL-CHANNEL ON-CAMERA UHF WIRELESS MICROPHONE SYSTEM 1-12-17 Kamirenjaku Mitaka-shi Tokyo 181-8533 Japan Tel :+81(0)422-55-5115 Fax :+81(0)422-55-0131 E-mail : sales@azden.co.jp URL http://www.azden.co.
PAGE 2
CONFIGURATION OF THE PACKAGES Adapted PLL synthesized control method provides constant audio receipt for dual audio receipt. First make sure matched channel is used between receiver 330UPR and transmitters such as 35BT (bodypack transmitter), 35HT (handheld transmitter) and 35XT(plug-in transmitter). To get best constant audio receiptant, should keep 10 channel difference between one microphone to the other microphone. For example, setting CH1:001, other channel CH2: 011.
PAGE 3
(10mW in Korea) For 3-pin XLR microphone inputs: Use the supplied min to dual XLR cable. Plug the mini-plug end of the cable into the receiver (user the screw-down sleeve to secure it to the receiver) and plug the XLR ends of the cable into the microphone inputs of the video chamera ⑨ Battery compartment Insert the fresh alkaline“AA”batteris into the compartment. Make sure the battery polarity is connect as marked inside the battery compartment. Batteries are not packed as standard item.
PAGE 4
Operation flow Conenct the standard parcked cable “stereo mini plug - dual XLR”. Connect the stereo mini plug side to the receiver and the dual XLR side to video camera. The dual XLR side, CH1 is white color marking and CH2 is black color marking. Make sure matching channel set between the receiver and video camera. Camcoder supports Phantom power supply through microphone jack. Set the Phantom power supply feature to “off” position. Otherwise, it may damage the receiver.
PAGE 5
Operating the system BODYPACK TRANSMITTER (35BT) Because this is a frequency agile system, the receiver and transmitter must be on the same channel number. To change the channel number, use the tip of the provided tool and press the UP or DOWN button to the desired channel. Make sure both the receiver and transmitter are on the same channel. (11) Remove the battery compartment lid by sliding it down.
PAGE 6
(19) POWER Switches the transmitter “ON” or “OFF”. (20) AUDIO Prior to first turning the 35XT “ON” it is best to set the AUDIO switch to “OFF”. When you are ready to begin transmitting, switch to “ON”. The “OFF” position acts as a “mute” that maintains the RF signal but turns off the audio. (21) MIC Connector/Locking Ring This 3-pin XLR connector is the microphone input. Any low impedance microphone with a corresponding connector can be attached here.