User's Manual

ManualsBrandsAzden ManualsMicrophones35XT

305 SYSTEM

User’s Guide

305UPR • 35BT • 35HT • 35XT

ON-CAMERA

UHF WIRELESS MICROPHONE SYSTEM

Azden Corporation, 147 New Hyde Park Road, P.O. Box 10, Franklin Square, NY 11010

tel - 516.328.7500 • fax - 516.328.7506 • email - azdenus@azdencorp.com

P1070-03

Printed in USA

Specifications

Due to constant improvements, specifications are subject to change without notice.

305UPR Receive

Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz)

Type of Reception FM

Oscillator PLL Synthesized

RF Squelch Level -95dBm

Frequency Response 50Hz – 15kHz

S/N Ratio >57dB (±5kHz) “A” Weighted

Audio Out MIC Level – Balanced – 3.5mm Mini-Jack

-58 bdBm – 600 ? @ ± 5kHz deviation

-22 ,dBm – 600 ? @ ± 40kHz deviation

Batteries 2 “AA” Alkaline (2 x 1.5V) - 3-4 hours runtime

2 “AA” rechargeable Ni-MH (2 x 1.2V)

Dimensions 2.48"W x 3.86"H x 1.12"D (63 x 98 x 28.5 mm)

Weight Approx. 6.7oz (190g) w/batteries

35BT Body-pack Transmitter

Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz)

Oscillator PLL Synthesized

RF Power 25mW

Frequency Response 50Hz – 15kHz

Max. Deviation ±40kHz @ 1kHz Modulation, MIC Input – 11dBm

Batteries 2 “AA” Alkaline (2 x 1.5V) – 8-10 hours runtime

2 “AA” rechargeable Ni-MH(2 x 1.2V)

Dimensions 2.48"W x 3.86"H x 1.12"D (63 x 98 x 28.5 mm)

Weight Approx. 6oz (170g) w/batteries

35XT Plug-In Transmitter

Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz)

Antenna Internal

Max. Input level -16dBm

RF Power 25mW

Input Impedance 25k ohms

Audio Adjust. Range -65dBm to 46dBm

Battery 2 “AA” Alkaline (2 x 1.5V) – 6-8 hours runtime

2 “AA” rechargeable Ni-MH(2 x 1.2V)

Dimensions 1.57"W x 1.57"H x 4.49"L (40 x 40 x 114 mm)

Weight Approx. 6.35oz (180g) w/battery

35HT Handheld Microphone/Transmitter

Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz)

Oscillator PLL Synthesized

RF Power 25mW

Frequency Response 50Hz – 15kHz

Max. Deviation ±40kHz @ 1kHz Modulation, MIC Input – 65dBm (dev ±5kHz)

Batteries 2 “AA” Alkaline (2 x 1.5V) – 8-10 hours runtime

2 “AA” rechargeable Ni-MH (2 x 1.2V)

Dimensions Φ1.89" x 9.2"L (48 x 234.5 mm)

Weight Approx. 9.5oz (270g) w/batteries

PRELIMINARY

Summary of content (4 pages)

PAGE 1
Specifications 305UPR Receiver Frequency Range Type of Reception Oscillator RF Squelch Level Frequency Response S/N Ratio Audio Out Batteries Dimensions Weight 35BT 35XT 305UPR • 35BT • 35HT • 35XT ON-CAMERA UHF WIRELESS MICROPHONE SYSTEM Body-pack Transmitter Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz) Oscillator PLL Synthesized RF Power 25mW Frequency Response 50Hz – 15kHz Max. Deviation ±40kHz @ 1kHz Modulation, MIC Input – 11dBm Batteries 2 “AA” Alkaline (2 x 1.
PAGE 2
Operating the system 20 Because this is a frequency agile system, the receiver and transmitter must be on the same TV:Receive/Transmit channel number. To change the channel number, use the tip of the provided tool and press the UP or DOWN button to the desired channel. Make sure both the receiver and transmitter are on the same channel. 4 3 6 305UPR Receiver 22 8 18 5 7 9 After installing new batteries, mount the receiver to your video camera with the supplied shoe mount or hook & loop fastener.
PAGE 3
HANDHELD MICROPHONE/TRANSMITTER (35HT) (24) Insert two fresh Alkaline* “AA” batteries* into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment. Thank you for purchasing Azden’s 305 wireless microphone system.
PAGE 4
(6) PHONE jack: Plug a headphone into this 3.5mm jack to monitor sound. (7) Shoe-Mount: Attach the 305UPR to the shoe-mount of the video camera by sliding it into place. Turn the thumbwheel clockwise to tighten. Reverse this procedure to remove. (16) AUDIO: Prior to first turning the 35BT “ON” it is best to set the AUDIO switch to “OFF”. When you are ready to begin transmitting, switch to “ON”. The “OFF” position acts as a “mute” that maintains the RF signal but turns off the audio.