Installation Guide

Page 9Page 8
Parts
• AZEK
®
Column Wraps are not structural and are not intended for load bearing applications.
• Manufactured edges of the column wrap are sharp and should be handled with care.
• AZEK Column Wrap should be installed in accordance with the local building codes and the installation guidelines
included below. AZEK Building Products Inc. accepts no liability or responsibility for the improper installation of
this product. Failure to install AZEK Column Wrap in accordance with applicable building codes and this Installation
Guide may lead to personal injury, affect product performance and void the product warranty.
• AZEK Column Wrap may not be suitable for every application. It is the sole responsibility of the installer to be sure
that AZEK Column Wraps are fit for the intended use. Since all installations are unique, it is also the installer’s
responsibility to determine specific requirements in regards to each application.
• AZEK Building Products recommends that all applications be reviewed by a licensed architect, engineer, or local
building official before installation. If you have any questions or need further assistance, please call AZEK Customer
Service at 877-ASK-AZEK (877-275-2935) or visit our website at AZEK.com.
WARNING! Please read all instructions completely before starting any part of the installation.
Installing Column Wrap
Slickplane® Tool
UNIVERSAL
SKIRT BOARD
Cement
Board Siding
Be sure cement board siding
compresses the integrated rubber
gasket
This is a two part product. Choose trim nish by facing either Traditional or Frontier out. Insert Universal Skirt Board interface via
press t. Once inserted, USB interface cannot be removed.
Vinyl Siding
SIZES
Trimboard
• 5/4 x 6, 5/4 x 8 and 5/4 x 10
in 18’ lengths
Universal Skirt Board Interface
• 1
1
⁄2” nailing ange
•
1
⁄4” drip edge overhang
IMPORTANT: Flash according to water barrier
manufacturer guidelines. Use common accepted
building practices to prevent water inltration.
Fasten using nail (minimum 1 1/2” long
with minimum of 5/16” head) in every
other hole
Fasten trimboard according to standard
AZEK Trim guidelines.
Keep pieces together
while measuring and
cutting for a more
accurate fit
INTEGRATED
DRIP EDGE
This is a two part product. Choose trim finish by facing either
Traditional or Frontier out. Insert Integrated Drip Edge interface
via press fit. Once inserted, IDE interface cannot be removed.
Windows to be
installed per
manufacturers
recommendations
SIZES
Trimboard
• 5/4 x 4 and 5/4 x 6 in 18’ lengths
Integrated Drip Edge Interface
• 1 1⁄4” nailing flange
• 1⁄8” drip edge overhang
Fasten using nail
(minimum 1 1/2”
long with
minimum of 5/16”
head) in every
other hole
IMPORTANT: Flash according to water barrier
manufacturer guidelines. Use common accepted
building practices to prevent water infiltration.
Fasten trimboard according to
standard AZEK Trim guidelines.
Keep pieces together
while measuring and
cutting for a more
accurate fit
Installation Guidelines for AZEK
®
Trim and Moulding
MEASURE POST HEIGHT AND CUT
COLUMN WRAP TO DESIRED LENGTH
Measure height of post.
Stack and cut
AZEK
®
Column
Wrap to desired
length.
Three panel
column attached
Align loose locking panel
INSTALL SHIMS TO
POST IF NEEDED
If necessary, install
thin shims to the top,
middle and bottom of
the structural post so
that the Column Wrap
fits tightly around the
structural post. Shim all
four (4) sides evenly to
maintain equal spacing
around the post. Be sure
the shimmed outside
dimensions are no
wider than the inside
dimensions of the AZEK
Column Wrap.
(Optional)
1
Make
sure three
connected
panels and
locking
panel are cut
evenly.
2
Installing Column Wrap