Installation Guide

Page 11Page 10
AZEK
®
Trim Care & Cleaning
CARE & CLEANING
• Power wash or hose off any loose dirt or debris. Make sure to test the setting for the power washer
to ensure it will not damage the surface of the board.
• If the board does not come clean, AZEK Trim products can be cleaned with TimberTech
®
Deck
Cleaner™ or Oxyclean and a medium nylon bristle brush. Rinse with a hose or power washer (be
sure to test the pressure so it does not harm the surface of the board). Other cleaning methods
include using a soft cloth and a mixture of mild detergent. A Mr. Clean Magic Eraser has been
shown to work on pencil or other black marks. Other methods include denatured alcohol, mild
household spray cleaner like Simple Green or Krud Kutter Cleaner/Degreaser. When using
cleaners other than a mixture of mild detergent and water, it is best to test on a small area, or
a scrap piece of AZEK Trim, to make sure it does not harm the surface or damage the product’s
appearance. Always read the cleaning product manufacturer’s specific information before using
any product on your AZEK Trim and follow their instructions.
• WARNING: KEEP CHILDREN AND PETS AWAY FROM CLEANING PRODUCTS AND THE TRIM UNTIL
COMPLETELY DRY.
• IMPORTANT: DO NOT USE SOLVENT BASED CLEANERS AS THEY CAN HARM THE FINISH OF
AZEK TRIM.
Consult with your paint manufacturer for instructions on cleaning AZEK Trim that has already
been painted.
For any other questions on AZEK Trim, visit AZEK.com or call us at 877-ASK-AZEK [phone].
ADD ADHESIVE TO
THREE PANEL
COLUMN WRAP
PLACE THREE PANEL COLUMN
WRAP AROUND POST
SNAP THE LOCKING
PANEL TO THE THREE
PANEL COLUMN WRAP
Fold and lock
panels together
horizontally
and place the
column wrap
around the post
as shown.
Fit the tongue of the locking
panel into the grooved ends of
the folded three connected pan-
els. Carefully apply pressure
with a clean rag so it snaps into
place. Secure/clamp Column
Wrap to allow adhesive to cure.
Apply a small bead of Cellular PVC adhesive to the bead/
groove corner joints and grooved female ends of the three
panel column wrap.
Acceptable
Adhesives:
• AZEK Cellular PVC
Cement
• Devcon Trimbonder
• AZEK Fast Cure
Adhesive
• OSI TeQBond
Remove
tape
from joint
prior to full
cure and wipe
excess adhesive
off edges.
Note:
When using AZEK Column
Wrap around a post in a railing
application, solid blocking must
be attached between the post and
the AZEK Column Wrap. Refer
to your local building code for
details.
FASTEN COLUMN
WRAP TO POST / EASE
EDGES
Column Wrap may be
fastened to the post
using stainless steel
nails or exterior grade
screws. Nail or screw
holes can be easily
filled using a sealant
or comparable products
formulated specifically
for use with cellular
PVC.
(Optional)
Recommendation: Use
hand held Slickplane
®
tool
to ease edges
after tape is
removed.
WIPE EXCESS
ADHESIVE OFF
WITH CLEAN
RAG
Apply adhe-
sive in the
orange areas.
3
4
Start at the
bottom of
the three
panel AZEK
Column
Wrap.
5
6
7
If possible position
fasteners where they
can be covered by
mouldings.
Warning: Do not apply
excessive adhesive to
corner joints.
Installing Column Wrap