Installation Guide

Page 8
4
COMPLETE INSTALLATION
• Place the next plank into position against the fasteners. Slightly raise the
outer edge of the plank being installed and slide it onto the fastener until
the plank contacts the spacer tab. When properly installed the inserted
plank should be in contact with the bent-forward spacer tab at the left
end of the clip. To achieve this use a scrap piece of decking at least 24”
in length and use it as a tamping block to drive the plank further onto
the clip and the screw will fully engage the plank to the spacer tab if not
already in contact.
• Do not use a hammer or damage to the edge of the plank may occur.
a.
b.
c.
5
• Joists at butt joints must be doubled up for proper fastener attachment.
• Install fasteners as detailed below. Note that the two clips on the right
are shifted approximately 1/4” to the right of center on the joists. If this
is not done the spacer tab may fall within the gap of the butt joist.
HOW TO INSTALL AT BUTT JOINTS
(UNLESS USING AZEK L-BRACKET)
Offset 1/4”
From Center
CONCEALoc® Hidden Fasteners Installation