Installation Guide

Page 9
CONCEALoc® Hidden Fasteners Installation
6
• When the deck is located in a corner of the house, start with small
triangular piece of decking in the corner and work your way out.
• Offset the clip 1/2” to the right of center line of the joist, so screw will not
exit the side of the joist when driven.
HOW TO INSTALL ON DIAGONAL
Incorrect Correct: Shift over 1/2”
7
• Make two parallel cuts down the center of the board to be replaced,
then remove the center piece.
• Using a small pry bar, remove the remaining pieces of decking from
the tabs.
• Using a reciprocating saw, remove the tabs on the side of the board with
the screw heads showing.
• Position new board into place, and drive onto remaining tabs.
• Once the board is set into position, secure the loose edges with L-Bracket,
Cortex, stainless steel, or high-quality coated deck screws.
HOW TO REPLACE A PLANK