User's Manual

User Manual
Page 46 of 73
To create a new Static Route, click Add. The Routing-Static Route Add page will shows up.
The key settings for adding a new Static Route are explained:
Destination Network Address Enter the network address to which the data packets are to be
sent.
Subnet Mask Enter the subnet mask for this destination.
Use Gateway IP Address If you wish to use a specific gateway to reach the destination
network, select this checkbox and then enter the IP address of the gateway.
Use Interface If you wish to use a particular WAN interface, select the checkbox and select the
interface.
Click Save/Apply to take effect the settings.
To delete the entry from the routing table list, click its corresponding Remove button.
RIP