User's Manual

User Manual
Source Port Enter the port number used by the application to block.
Destination IP Address/Subnet Mask Enter the IP address of the remote server to
which connection should be blocked.
Destination Port Enter the destination port number used by the application to
block.
Click Save/Apply to take effect the settings. The new rule will then be displayed
in the Outgoing IP Filtering table list.
To delete the rule, click Remove checkbox next to the selected rule, and click
Remove.
Incoming IP Filtering
By default, when NAT is enabled, all incoming IP traffic from WAN is blocked except for
responses to requests from the LAN. However, some incoming traffic from the Internet
can be accepted by setting up Incoming IP Filtering rules.
To create a new incoming IP filter, click Add. The Add IP Filter-Incoming page will be
displayed.
Page 40 of 72