Manualshelf

User manual

ManualsBrandsAztech ManualsNetworkingEasy
21222324252627282930
User Manual
Page 23 of 48
Power Saving Mode
After 15 minutes of Ethernet inactivity, HomePlug AV will enter Power Saving Mode. The
Power LED will start BLINKING slowly to indicate its Power Saving Status.
Conditions of a HomePlug AV on a Power saving mode:
- Power LED is blinking slowly
- Powerline Activity LED and Ethernet LED are turned OFF.
- When connected to a PC or Laptop, if there is network card inactivity, HomePlug AV
is also on a Power Saving mode.
Note: If another device is on a Power Saving Mode, the Homeplug AV Utility may detect the
device but would be unable to configure its respective setting.