Setup guide

ManualsBrandsAztech ManualsComputer equipmentIn-Home Display (IHD)

Quick Setup Guide - Elster EnergyAxis

Please contact your utility company for support

Visit myaztech.ca for product User Manual and Configuration Manual

Step 1: Power up your In-Home Display (IHD)

Plug the AC power adaptor into a 120 V AC wall outlet and press the Power button on the right side of your IHD. While your

IHD is normally plugged in, you can unplug it and use Quick Read mode* to spot-check the energy efficiency of your appliances.

Initially, the IHD must be plugged in for at least 4 hours to charge the battery.

Step 3: Wait for IHD to connect to your meter

During this process,

• “Waiting for Utility” will be displayed

• and the light bar will glow red, sweeping back and forth.

When the meter connection is found,

• the information screens will become available for viewing

• and the IHD will begin receiving information from the Smart meter.

Most Smart meters will provide new data every minute. If you are not consuming

much electricity, it may take several minutes or longer to notice any changes.

Note: some meters only provide data hourly.

If no connection is found after 15 minutes,

• move the IHD closer to the meter and allow additional time for the IHD to

connect to the meter.

If no connection is found after moving closer to your meter, please contact

your utility to confirm that your IHD has been registered. Please provide the

following information to your utility:

• LAN ID

• Serial Number

This information is found on the label on the bottom of your IHD.

* Use Quick Read Mode to check the impact of any given appliance on your electricity usage by

comparing the change in usage readings before and after starting the appliance.

NOTE: ALL COSTS ARE FOR INFORMATIONAL AND EDUCATIONAL PURPOSES ONLY AND NOT FOR BILLING.

Step 2: Select Language

• Select the language by using the up or down buttons to scroll.

• Press the center navigation button to select the desired language.

This selection impacts labels on the information screens and menus.

Select

Power

Aztech Associates Inc. provides a limited one year warranty for this product. For details or to obtain warranty support, please visit myaztech.ca

any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of Aztech Associates Inc.

Summary of content (2 pages)

PAGE 1
Quick Setup Guide - Elster EnergyAxis Please contact your utility company for support Visit myaztech.ca for product User Manual and Configuration Manual Step 1: Power up your In-Home Display (IHD) Plug the AC power adaptor into a 120 V AC wall outlet and press the Power button on the right side of your IHD. While your IHD is normally plugged in, you can unplug it and use Quick Read mode* to spot-check the energy efficiency of your appliances.
PAGE 2
Step 4: IHD Operation Scroll up and down through screens IN COST MODE Switch between cost and usage modes Power/ Menus IN USAGE MODE *Where data is available FCC Notices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.