Setup guide

Scroll up and down through screens
IN COST MODE
IN USAGE MODE
Step 4: IHD Operation
*Where data is available
FCC Notices
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment uses and generates radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: reorient or relocate the receiving
antenna; Increase the separation between the equipment and receiver; connect the equipment into an outlet on a circuit different from that to which the receiver
is connected; consult the dealer or an experienced radio / TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. To comply with
FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This
device must not be co-located or operated in conjunction with any other antenna or transmitter.
Power/ Menus
Switch between cost and usage modes
S 097- 0905 E00 Please contact your utility company for support myaztech.ca
Product is protected under US Patent 8325057, China Patent 101765758, Japan Patent 5026530, NZ patent 579331. Other patents pending.