User manual

Select Progress Bar
Mode
Informational Screens
Current Usage
Your Aztech In-Home Display provides the unique ability to show your
current usage in three viewing options.
Press the mode button to switch between the cost ($) or usage (kWh)
views of your energy consumption.
In Cost Mode
The average energy being used and its associated cost based on the
current electricity rate are presented. This information is typically
updated every minute.
In Usage Mode (kWh)
Each light bulb represents 100 watts of electricity being used.
If the amount of electricity is greater than the number of light bulbs
that can be displayed (60 bulbs or >6000 W), the display will
automatically revert to the cost mode view.
Quick Read
The Quick Read feature enables you to get frequent information about your electricity use. To learn how the use
of a particular appliance impacts your electricity usage, compare the reading before and after starting the
appliance.
Press the select button to start getting quick reads of your current
usage from your Smart meter.
This screen will update approximately every 15 seconds providing
you with up to date information about your whole home usage.
The progress bar at the bottom of the screen lets you know how
soon the next reading will be obtained from your meter.
Each time the progress bar disappears a new reading is being
obtained, and the progress bar will begin to count down again.
Press the up or down navigation button to return to the
information screens.
After 4 minutes, the display will return to the screen that was displayed when the Quick Read was requested.
D 097-0905 B01 7 myaztech.ca