Model name: L1S Phone layout The phone has 21 keypad keys,and a charger/headset port. 1. Earpiece 3. Left key 5.Call/Dial Key 7.Navigation Keys 9.MIC 11.Back Cover 2. Display 4.Right key 6.End/Power Key 8.Center Key 10.
1、Switch On/Off the Phone To turn on/off the phone, press and hold the End/Power key. If you have enabled the SIM Lock function then enter the PIN code (the 4 to 8 digits secret code of your SIM card). It is preconfigured and provided to you by your network operator or retailer. If you enter an incorrect PIN code 3 times in succession, your SIM card will be locked. To unlock it, you must obtain a code from your network operator.
now locked.When you turn it on,you will be asked for the password.To deactivate ,repeat the process. 4. How to enable Data access From main menu, select Settings, then Manager Connections, Data account. Then choose your SIM operator, and Activate. 5.
6. How to insert micro SD card The memory card is a pluggable mobile storage card inside the mobile phone. To install the memory card, open its latch, place its indented side downward, insert the card into the card slot, and then close the latch. To remove the memory card, open its latch and slightly press the card inward. The card will automatically pop out. Close the latch. Note: 1. The mobile phone cannot automatically identify the memory card being inserted when the mobile phone is powered on.
Set an alarm 1 Go to Tools>Alarm. 2 Select an alarm, press Edit to edit the alarm. 3 Press right soft key to finish setting the alarm. Turn off an alarm 1 Go to Tools>Alarm. 2 Select the alarm you want to turn off, press Edit. 3 Press the navigation key to select Off then press right soft key to save. Stop an alarm When the alarm rings, • Select Stop: The alarm stops. • Select Snooze: The alarm will sound again after the set Snooze (min) interval. 9.
Voltaje Pantalla 屏幕电压 Corriente eléctrica Llamada 通话电流 Voltaje Llamada 通话电压 Voltaje Off 关机电压 Cargador Entrada 充电器输入电流电 压 Salida 充电器输出电流电压 3.5-4.2 V 150-280 MA 3.6-4.2 V 3.4 V 100-240 Vca, 50/60HZ 150MA 5.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 15mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
