Installation & Assembly

INSTALLATION GUIDE
ST-05
STANDARD STRAINER
Products and specifications shown are subject to change without notice. Please contact our technical support at [e-mail] for any further queries, replacement parts requests, etc. ©2021 AZUNI
®
all right reserved.
1. Rinse the strainer with water.
2. Coat the strainer with baking soda, Flitz or Barkeepers friend.
3. With sponge, scrub strainer and all sink walls in the direction of
4. Spray on undiluted vinegar.
AZUNI PRODUCTS
the steel grain.
azuniproducts
azuniproducts azuniproducts
[phone]
WARRANTY
CARE AND CLEANING
5. Rinse again.
6. Buff with a few drops of olive oil.
7. If necessary, repeat procedure.
TOLL
FREE
For additional technical assistance or for any questions or concerns about your kitchen strainer's warranty, please contact us.
www.azuni.ca/warranty
www.azuni.ca
[e-mail]
IF YOU HAVE PURCHASED A STANDARD STRAINER, PLEASE MAKE SURE TO READ THESE INSTRUCTIONS CAREFULLY
Place foam gasket and strainer body on
the top side of drain opening.
Alternatively Plumber's Putty could be
used instead of foam gasket.
From underneath bring outer basket with
rubber gasket under the sink and secure
with basket nut.
Tighten basket nut using channel locks or
wrench.
Insert tail pipe with nut into home's
plumbing, then align and secure
tail pipe nut to strainer body.
Tighten tail pipe nut to strainer body,
ensure the rubber gasket is present.
Run water and confirm no leaks.
1 2
3
4 5
6
Sink
Foam
Outer
gasket
Rubber
gasket
Basket nut
Rubber
gasket
Basket
Strainer
body
Tail pipe
Tail pipe nut