Owner's Manual

12
Installation Instructions (continued)
Installing the Handle
1. Remove the door gasket on the side you wish to install the
handle. Under the gasket you will see two designated
holes for handle installation
2. Install the handle tightly as shown above with two screws,
lock washers and flat washers provided.
3. Replace the door gasket.
Reversing the door swing of your appliance
Should you desire to reverse the opening direction of the door, please follow the instructions below:
Note: All parts removed must be saved to do the reinstallation of door
1. Lock screws
2. Right lower hinge
3. Door shaft assembly
4. Right top hinge
5. Glass door
6. Cabinet
7. Left top hinge
8. Left lower door hinge
1. Open the glass door and remove the two screws, under the right bottom corner of the door, that are used to
hold the right lower hinge to the door shaft assembly. Be careful to support the door with both hands to
prevent it dropping after removing the screws. (Figure 1)
2. Pull down to remove the door and place it on a padded surface to prevent scratching it. (Figure 1)
3. Remove the right top hinge and right lower hinge. (Figure. 3). Take the left top hinge and left lower hinge
from the plastic bag that includes the instruction manual then install them in the designated positions on the
left side of cabinet. (Figure 4)
4. Turn the glass door around 180º and then relocate the door to the designated position.
5. Then screw the bottom hinge assembly on the left designated position and tighten it after the door is leveled.
(Figure 6)
6. Reassemble the ventilation grills.