Owner's Manual

9
Installation Instructions
Before Using Your Azure Appliance
 Remove all exterior and interior packing.
 Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system caused by handling during transportation.
 Clean the interior surface with warm water using a soft cloth.
 The door on this appliance can be opened from either the left or the right side. The unit is delivered with the
door opening on the left side. Should you wish to open the door from the right, follow the instructions,
“Reversing the Door Swing of your Appliance,” listed below.
Installation of Your Appliance
 Azure appliances are designed for either built-in, or free standing installation.
 Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level your
appliance, adjust the 4 legs until level.
 Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
 Never located the unit in damp areas.
 Plug the appliance into an exclusive, easily accessible electrical socket.
 Any questions concerning power and/or electrical connection should be directed towards a qualified
electrician or an authorized products service center.
 The air vent at the front of the appliance must never be covered or blocked in any way.
 The appliance must be installed to all electrical, plumbing, water and drain connections in accordance with
state and local codes.