Azurewave / AW-BT252 Bluetooth Module User Manual
Install the Bluetooth Driver…………………………………………..2 Connect to other Bluetooth Enabled Devices……………………..7 Uninstall the Bluetooth Driver……………………………………….
Install the Bluetooth Driver Step1:Double click WIDCOMM Bluetooth Software 6.0.1.
Step2 :Choose 『I accept the terms in the license agreement』 3
Step3:Double click 『Next』 4
Step4:Choose『Install』 5
Step5:Install finish 6
Connect to other Bluetooth Enable Device Step1: Search new Bluetooth devices.
Step2 : Double click 『Next』 8
Step3 : Double click 『Next』 9
Step4: 10
Uninstalling the Bluetooth Driver Step1: 11
Step2: 12
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna, As long as 1 condition above is met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
For Taiwan 警語 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻 率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立 即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線 電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之 干擾。 Note: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤 2.