User's Manual

- 13 -
H.TX Testing
1. In the HCI Control window
a. select 0: Vendor-specific Commands (0 key) for HCI protocol active
b. Double-click TX Test
2. In the HCI command window
a. From the Local_Device_BD_ADDR shortcut menu, select the Bluetooth device address of the DUT.
b. From the Hopping_Mode shortcut menu, select single frequency.
c. From the frequency shortcut menu, select which frequency you want to test.
d. From the Modulation_Type shortcut menu, select PRBS9 Pattern.
e. From the Logical_Channel shortcut menu, select ACL Basic.
f. From the BB_Packet_Type shortcut menu, DH5/3-DH5, DH3/3-DH3, or DH1/2-DH1.
g. From the BB_Packet_length(….) shortcut menu, key 65535
h. From the Tx Power Level shortcut menu, select Specify Power in dBm
i. From the Transmit Power dBm shortcut menu, key in which power you want to transmit.
j. Click OK.
3. Confirm that this step is done successfully by viewing the log window.