AW-CU484 IEEE 802.15.4 and Bluetooth LE 5.0 wireless microcontroller Stamp LGA Module User Guide Rev.
Revision History Version Revision Date A 2020/11/23 Description Initial Version Initials Approved Shihhua Huang N.C.
1. System Setup (1) Hardware Requirements Host system need running the Windows10 x64 operating system IQxel-M8 RF isolation chamber for receive measurements.
(2) Software Requirements PL-2303GC Driver Tera Term (tool) Note: Tera Term is our suggestion, you can try any terminal tool. DK6Production flash programmer folder (please contact FAE) Note: You must have below files Mbt.exe (please contact FAE) Note: mbt is our suggestion. You can try any hci tool.
2. How to download the image 1. You must check the COM number (can check the value by the following picture) Note: J9 for DUT COM port 2. Find the folder of DK6ProductionFlashProgrammer, and type cmd to get into the Dos window.
3. Key in ZIGBEE IMAGE: DK6Programmer.exe -s com6 -p JN-AN-1242-JN518x-Customer-Module-Evaluation-Tool.bin BLE IMAGE: DK6Programmer.exe -s com6 –p qn9090dk6_hci_black_box_bm.bin *You must note the step. If you key in the format before getting into download mode (DK6Programmer.exe -s com6 -p JN-AN-1242-JN518x-Customer-Module-Evaluation-Tool.bin), you need to keep holding the ISP button and Reset button, and then release the ISP button after releasing the reset button.
5.
3. Test mode(In Zigbee) 3. 1. Open the Tera Term 2.
4. Select a) standard module 5.
6. Customer Module Evaluation Tool (main menu) Select “g” trigger packet test (Rx test) Select “I” transmit packet test (Tx test) ----------------------------------------------------------------------------------------------------------------------------- ---------------- 1.
2.
3.
4. Read contents of EEPROM Can read the NFC MAC in Block 0: 04830C3AE26180 Open the NFC Taginfo on you smart phone, and scan the NFC, Then you will get the information from NFC.
5. Write data to EEPROM Use this test to write data to EEPROM, Format is: 1:0 1 2 3 4 5 6 7 8 9 A B C D E F Programs 0 to F in block 1 Check the Format again.
4. Test mode(In BLE) 1. Open the folder of mbt 2. Open the mbt_setup.
3. And type cmd to get into the Dos window. 4. Key in mbt.
5. Main menu If you need more information, please key in mbt help. 6. Key in mbt reset Make sure the DUT have been reset.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Antenna Information Ant. Brand 1 LYNwave Model Name ALX20M-052AA1 Antenna Type PIFA Antenna Gain (dBi) 2.8 This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
