User Manual

3
-
4
Wi-Setup Wizard Steps
Whatever which wireless configuration you would set up, the first scene of Wi-Set Wizard is
“Select Operation Mode” dialog that shows as right picture. You could select either station or
AP mode from the first step.
For Ad-hoc and infrastructure type configuration, you should select Station mode. The software
access point configuration could be archived by select AP mode.
 Station
Set the operation mode to be “Station”. Follow steps in section 4.3.
 AP
Set the operation mode to be “Access Point”. Follow steps in section 4.4.
 Next
Go to next step of selected mode.
 Cancel
Give up Wi-Set Wizard. The default wireless configuration will be automatically applied as
“Infrastructure” type of Station mode if user won’t set it up here.
3.3 Station Mode Configuration
Two types, infrastructure and ad-hoc types, of station mode are provided here.
 Infrastructure
Configure the wireless as infrastructure type network.
Follow steps in 4.3.1 Build Infrastructure type
network.
 Ad-Hoc
Configure the wireless as Ad-Hoc type network.
Follow steps in 4.3.2 Build Ad-Hoc networking mode
network
 Back
Go back to previous step – Select Operation Mode.
 Next
Go to next steps of selected type.
 Cancel