AW-GD200 Linux Driver Installation & User Guide Version: 1.
History Version 1.0 1.1 Date 2005/08/01 2005/10/20 Description First Edition Add iwconfig user command Table of Contents AW-GD200 Installation and User Guide ………………………………………… History ………………………………………………………………………………. Table of Contents …………………………….…………………………………… Introduction ………………………………………………………………………… 1.1 Installation …………………………………………………………………… 1.1.1 Adapter Linux Driver …………………………………………….………... 1.1.2 Installation and Configuring the Linux Source Tree ………………. 1.1.
Introduction This guide explains how to install the following software on a Linux based desktop or laptop computer: - AW-GD200 Driver for Linux system This adapter can be used in a non-PC device to easily enable Wireless connectivity. 1.1 Installation The installation procedure includes two main steps: 1. Compile the Driver 2. Install the Driver 1.1.1 Adapter Linux Driver The driver is distributed in source-code format.
1.1.4 Install the Driver After inserting the adapter, you can run insmod deep31.o to load the driver into the kernel. 1.1.5 Overall Installation Procedure As a summary, the overall installation procedure for Linux driver is as below: 1. Extract the source into any directory. For example, cd /usr/src tar xvzf mb31ep_sdk_2_1_x_x.tar.gz 2. Go to the created directory and then compile the source code cd MB31-DeepLinux make clean make This should create the file deep31.
2.0 Configure a wireless network interface The following describes the configuration of AW-GD200 wireless driver using the wireless extension tools. 2.1 iwconfig iwconfig is dedicated to the wireless interfaces. It is used to set the parameters of the network interface which are specific to the wireless operation (for example: the frequency). iwconfig may also be used to display those parameters, and the wireless statistics.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
DGT 警語 : 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自 變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象 時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法 規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用 電波輻射性電機設備之干擾。 本模組於取得認證後將依規定於模組本體標示審合格籤，並要求平台上標示[本 產品內含射頻模組:ID 編號] 2
