WirelessHD Tx/RX Box User’s Manual
FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IC Statement This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B onforme á la norme NMB-003 du Canada. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Index 1 Introduction ...................................................................................................................... 1 1.1 Product Layout ........................................................................................................ 1 1.2 Features ..................................................................................................................... 1 1.3 Package Content ...................................................................................
1 Introduction AW-WH036T and AW-WH036R is a whole set of WirelessHD products. They can stream uncompressed audio and video up Full HD (FHD) resolution. It works at 60GHz band which is available on an unlicensed basis in many regulatory domains with a typical range of 10 meter. AW-WH036T and AW-WH036R replaces the HDMI cable and simplifies home theater system installation. The source devices, such as BD player or Set Top Box, don’t need to be located near to the TV. 1.
Array Antenna HDMI 1.3 Compatible DTCP (Digital Transmission Content Protection):AES-128 CTR mode HDCP 2.0 Support 1.3 Package Content The package include the below package content: One set of AW-WH036T and AW-WH036R Power Adapter User’s Manual 1.4 Specification Table Model Name AW-WH036T & R Product Description HDMI (type-A ) wireless module WirelessHD Standard WirelessHD V1.0 HDMI Standard HDMI 1.
YCbCr: 4:4:4 Audio Channel 2~8 Sample Rate 32-192kHz RF Specifications 57~66GHz Frequency Range HRP: OFDM with QPSK , 16-QAM Modulation LRP: OFDM with BPSK Occupied Bandwidth HRP:1.76Ghz LRP: 92Mhz HRP: TBD Output Power LRP: TBD HRP: TBD Receive Sensitivity LRP: TBD HRP: Up to 3.807 Gb/s Data Rates LRP: Omni-directional mode Up to 10.168 Mb/s Indoor: 10 m Operating Range (The transmission speed may vary according to the environment) DTCP: AES-128 CTR mode Security HDCP 2.
1.6 Connectors and end-user interfaces Item Function 10-pin connector For upgrading firmware usage DC Jack For power supply HDMI Type A connector For HDMI input or output Main Power Switch Switch between power on and power off Push Button For setup application 2 Installation Steps 1. Remove the WirelessHD products and accessories from package 2. Connect the power adapter to the WirelessHD product and power outlet. Connect to power outlet via power adaptor 3.
Switch to “On” status 5. Make sure that “ ” in front side of WirelessHD product is “On” 6. After 10 ~ 30 seconds auto-connection, the orange LED will be “On”. it means that the products begin working.
3 Important Notice The Power adapter must be 5A / 2A. The WirelessHD products are only for indoor use, the transmitting distance is suggested to be less than 10 meters and no blocks between TX and RX. Always check the LED lights for troubleshooting.
