Data Sheet

26
FORM NO.: FR2-015_ A Responsible Department：WBU Expiry Date: Forever
The information contained herein is the exclusive property of AzureWave and shall not be distributed, reproduced, or
disclosed in whole or in part without prior written permission of AzureWave.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance,
the following conditions must be strictly followed when using this certified module:
KDB 996369 D03 OEM Manual v01 rule sections:
2.2 List of applicable FCC rules
This module has been tested for compliance to FCC Part 15.247
2.3 Summarize the specific operational use conditions
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions
such as co-location with other transmitter(s) or being used in a portable condition will need a
separate reassessment through a class II permissive change application or new certification.
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
The AW-NM512 is designed for 50 Ohm characteristic impedance, and the connection between AW-
NM512 and antenna should all be designed for 50 Ohm characteristic impedance. If using PCB
connections, should design the PCB layout for 50 Ohm characteristic impedance using microstrip,
stripline, etc.
To maximize the radiated power (and corresponding communication range), the length of the
transmission line between AW-NM512 and antenna should be made as short as possible. In order to
minimize interference between traces, they should be adequately spaced. Ideally, all RF traces should
be surrounded on the same layer by ground fill.