User manual

Sliding Coupler

Foot

Section Rod

Head Section Rod

US5000 SEMI-ELECTRIC: HEAD SECTION TO FOOT SECTION ROD CONNECTION

Sliding Foot Section Coupler onto Head Section Rod

1. Ensure the Head and Foot Sections have been properly assembled as described.

2. Once the Head Section Pins have been properly seated into the Foot Section Slots and the

Decks are engaged and aligned, you must connect the Manual Hi / Lo Drive Rod (Hi / Lo Rod).

3. The Foot Section Rod features a Sliding

Coupler, shown at right. With the Lanyard

Assembly disconnected (see below right),

slide the Foot Section Sliding Coupler

forward as shown at near right until the

small hole at the end aligns with the small

hole in the Head Section Rod.

Insertion of Retaining Lanyard

1. The Lanyard Assembly (690-8001-960)

should come pre-assembled with a Clevis

Pin, Washer, External Retaining Ring,

Lanyard, and Hair Pin Clip. It should also

be attached to the Lanyard Clip (100-1100-

053) on the side of the Hi / Lo Rod.

2. If the Hair Pin Clip is assembled within the

end of the Clevis Pin, pull it out.

3. Align the Coupler hole with the Hi / Lo Rod

hole and insert the Clevis Pin.

4. From the bottom, re-insert the Hair Pin Clip

into the end of the Clevis Pin to secure.

Lanyard

Assembly

08-670201-01

Lanyard Clip

100-1100-053

Hair Pin Clip

attached to

Lanyard

Clevis Pin

attached to

Lanyard

US5000-INS-LAB-RevA14