User manual

4. Insert the clevis pin through the holes and secure with the locking pin. See the following
instruction for locking pin installation.
Info: When the legs are lifted to align the holes in step 3, the spring buttons in the leg arm
tubes will be released and prevent the legs from returning to the low shipping position.
Once the Hi / Lo Motor is attached there is no need to disassemble the clevis pin and motor
again unless you are inserting it back into the shipping carton. After you disassemble the
motor for carton reuse, the arm spring pins will have to be depressed manually to allow the
legs to lower to shipping height.
Motor Locking Pin Installation
(Refer to Pictures at Right)
1. Insert locking pin into clevis pin hole.
2. Install locking pin through clevis pin hole.
3. Locking pin is shown locked into place on
clevis pin.
4. To remove locking pin: lift locking pin up and
push it back through clevis pin hole and out
of clevis pin.
Motor tube is shown at right locked into place.
Locking Pin
Clevis Pin
lift up
push back
US5000-INS-LAB-RevA14 15