User manual

Motor hooked onto Head Deck and
Knee Deck Motor Cams
Crossbrace Tubes
MUST seat into
Motor Chamber
cutouts on BOTH
Foot and Head Ends
DETAIL B
Hi / Lo Motor
Cord Retainer Clips
Y-Cable
Hi / Lo Motor
Plugs
4. Align the two large rectangular holes (Motor
Cam Chambers) on the Motor Ends with two
Motor Cams - one on the Head Section and
one on the Foot Section - as shown at right.
5. Push the Motor onto the Cams, ensuring
the Crossbrace Tubes are seated within the
Motor Cam Chamber cutouts as shown in
DETAIL B at lower right.
6. Once the Motor is in place, push with enough
force to snap it onto the Cams to secure it.
7. IMPORTANT: Replace the two Motor Covers
by sliding them back into place as shown in
DETAIL A on previous page.
8. After the Head / Foot Motor has been
installed and the Slide Motor Covers have
been attached, take note of the Hi / Lo Motor
Cord Routings shown on the next page.
The Head Motor Cord with loop is retained
under the Head Motor Crossbrace Tube. The
Foot Motor Cord is retained under the Leg
Lift Tube but is routed over the Knee Motor
Crossbrace Tube.
9. With the Motor Cords routed properly, plug
the Hi / Lo Motor Plugs into the Y-Cable
secured to the Head / Foot Motor.
10. After plugging in the Hi / Lo Motors, insert the
Motor Cords below the Motor Plugs into the
Cord Retainer Clips. Insure the Motor Plugs
are completely inserted into the Y-Cable and
the Y-Cable is completely inserted into the
Head / Foot Motor Port, next to the Pendant
Port.
US5000-INS-LAB-RevA14 18