USB Ranger® 2212 Cat 5 USB 2.
Thank you for purchasing the USB Ranger® 2212. Please read this guide thoroughly. This document applies to Part Numbers: 00-00252, 00-00253, 00-00254, and 00-00255. FCC Radio Frequency Interference Statement Warning This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation.
Contents Introduction ................................................................................................... Ranger Product Contents ............................................................................................................ Requirements ................................................................................................................................ About the Ranger ..................................................................................................
Introduction The instructions in this guide assume a general knowledge of computer installation procedures, familiarity with cabling requirements, and some understanding of USB devices. note NOTE: Notes provide additional information that could be useful. CAUTION: Cautions provide important information about an operational requirement.
The LEX unit The LEX unit connects to the computer using the attached USB cable. Power for the system is provided by the 24V AC adapter connected at the LEX unit. The LEX unit delivers power over the Cat 5 extension link to the REX unit. Front View 1 3 4 Rear View 5 6 ITEM TYPE 2 7 8 DESCRIPTION Power LED (Blue) LED turns on when power is supplied. Off when no power is supplied.
The REX Unit The REX unit provides USB Type A ports for standard USB devices. The REX unit allows you to connect up to two USB devices directly. Additional devices may be connected by attaching USB hubs to the REX unit up to a maximum of 14 USB devices or 3 USB hubs with 11 USB devices. The REX unit is powered via the Cat 5 link extension cable from the LEX unit. Each USB port delivers 500mA of power to the attached USB device(s).
Installation guide USB extension up to 100m Cat 5 (or better) cable Before you can install the Ranger 2212, you need to prepare your site: 1. 2. 3. Determine where the computer is to be located and set up the computer. Determine where you want to locate the USB device(s). If you are using surface cabling, the Ranger 2212 supports a maximum distance of 100m.
Connecting the LEX unit to the REX unit note To ensure proper operation, it is recommended that only Cat 5 or better, Unshielded Twisted Pair (UTP) cabling be used to connect the LEX unit to the REX unit. The cabling must have a straight-through conductor configuration with no crossovers and must be terminated with 8 conductor RJ45 connectors at both ends. The combined length of any patch cords using stranded conductors must not exceed 10m. With Surface Cabling 1. 2.
Connecting a USB Device 1. 2. 3. Install any software required to operate the USB device(s). Refer to the documentation for the USB device(s), as required. Connect the USB device to the device port on the REX unit. Check that the device is detected and installed properly in the operating system. Compatibility The Ranger 2212 complies with USB1.1 and USB 2.0 specifications governing the design of USB devices.
PROBLEM Link LED for RJ45 on LEX unit is on, Host LED on LEX unit is off. CAUSE • The host computer is not powered on. SOLUTION 1. Disconnect all USB devices from the REX unit. 2. Disconnect the LEX unit from the computer. • The LEX unit is not connected to the computer. • The computer does not support USB hubs. 3. Disconnect the LEX unit from the AC power adapter. 4. Reconnect the LEX unit to the AC power adapter. • The Ranger is malfunctioning. 5. Reconnect the LEX unit to the computer. 6.
USB device is attached to REX USB port but REX device LED is off. Device LED is orange and units are no longer functioning. • A USB device must have the 1. Install the required USB device driver on the appropriate driver installed on computer operating system prior to attaching the computer operating system. the USB device to the REX unit. Please see your USB device manufacturer’s website for details.
Frequently Asked Questions Please visit Icron’s website for answers to FAQs: http://www.icron.com/products/usb/faq.php Specifications Range 330 feet (100 meters) over Cat 5e (or better) cable USB device support High-speed devices (480 Mb/s) (USB 2.0) Full speed devices (12 Mb/s) (USB 2.0 & 1.1) Low speed devices (1.5 Mb/s) (USB 2.0 & 1.1) USB hub support Any single chain can include up to 3 USB hubs plus one Ranger 2212. USB host support EHCI (USB 2.0) and OHCI/UHCI (USB 1.
Limited Hardware Warranty Icron Technologies Corporation warrants that any hardware products accompanying this documentation shall be free from significant defects in material and workmanship for a period of one year from the date of purchase. Icron Technologies Corporation’s hardware warranty extends to Licensee, its customers, and end users.
Obtaining Warranty Service To obtain warranty service, you must contact Icron Technologies Corporation within the warranty period for a Return Material Authorization (RMA) number. Icron Technologies Corporation will not accept returns without an authorized RMA number. Be sure you have the serial numbers of the LEX unit and REX unit units before calling. Package the product appropriately for safe shipment and mark the RMA number on the outside of the package.
Technical Glossary Category 5 (Cat 5) Network Cabling Category 5 cable is commonly also referred to as Cat 5. This cabling is available in either solid or stranded twisted pair copper wire variants and as UTP (Unshielded Twisted Pair) or STP (Shielded Twisted Pair). UTP cables are not surrounded by any shielding making them more susceptible to electromagnetic interference (EMI). STP cables include shielding over each individual pair of copper wires and provides better protection against EMI.
Icron Technologies Corporation 4664 Lougheed Highway, Suite 221 Burnaby, BC, V5C 5T5 Canada Tel: 604-638-3920 Fax: 604-638-3930 www.icron.