Owner manual

Introduction

The instructions in this guide assume a general knowledge of computer installation procedures, familiarity

with cabling requirements, and some understanding of USB devices.

NOTE: Notes provide additional information that could be useful.

CAUTION: Cautions provide important information about an operational requirement.

Ranger 2212 Product Contents

Your Ranger 2212 is packaged with:

• LEXunit(LocalExtender)

• REXunit(RemoteExtender)

• LEXACpoweradapter(1)

USB Cable (6 ft)•

Quick Start Guide and Warranty Information•

The Ranger 2212 is a unique extender product that provides power over the Cat 5 link from the LEX unit to the REX unit.

The system does not require a power adapter at the REX to operate. The provided 24V, 1A power adapter must be

connected to the LEX unit for normal operation.

Requirements

To complete the installation, you will also require the following items that are not included with the product:

• USB1.1or2.0compatiblecomputer(hostcomputer)withaUSBcompliantoperatingsystem

• USB1.1or2.0compatibledevice(s)

• Cat5UnshieldedTwistedPair(UTP) cable with two RJ45 connectors (if using surface cabling),

OR, Cat 5 cabling with two information outlets and two Cat 5 patch cords with RJ45 connectors (if

using premise cabling)

All references to Cat 5 cable in this document represent the minimum requirement. Category 6 or better or STP cable

may be substituted.

About the Ranger 2212

The Ranger 2212 incorporates Icron’s patented ExtremeUSB® technology, enabling users to extend beyond

the standard 5m cable limit for USB peripheral devices. With the Ranger 2212, USB devices can be located up

to 100 meters from the computer.

The Ranger is composed of two individual units: the LEX unit and the REX unit.

The LEX and REX units may be hot to the touch when operating at or near the high end of the

certiﬁed temperature range.

note