Owner manual

Installation guide
Before you can install the Ranger 2212, you need to prepare your site:
1. Determine where the computer is to be located and set up the computer.
2. Determine where you want to locate the USB device(s).
3. If you are using surface cabling, the Ranger 2212 supports a maximum distance of 100m.
OR
If you are using premise cabling, ensure Cat 5 cabling is installed between the two locations,
with Cat 5 information outlets located near both the computer and the USB device(s), and
the total length, including patch chords is no more than 100m.
Installing the LEX unit
1. Place the LEX unit near the computer.
2. Install the supplied USB cable to LEX (Type B Port), and an available USB 2.0/1.1 Type A Port on the
computer.
3. Plug the 24V power adapter into a suitable AC outlet.
4. Connect the power adapter to the LEX unit.
Use only the AC adapter supplied with the Ranger 2212. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
Installing the REX unit
1. Place the REX unit near the USB device(s) in the desired remote location.
6
USB extension up to 100m Cat 5 (or better) cable