Specifications

Page 29

13.2. Other Supported Formats

The V-Smart shall support the following Pre-Defined Wiegand formats:

 Standard 26-bit

 Apollo 44-bit

 Northern 34-bit

 Northern 34-bit (no parity)

 Andover 37-bit*

 Generic 64-bit*

 Ademco 34-bit

 HID Corporate 1000 35-bit

 HID 37-bit

 Wiegand 4002 40-bit*

 Generic 34-bit*

If the Access Control System is configured for a Wiegand format other than

the default of Standard 26-bit, then the software shall be required to select

the supported format.

Only one format may be selected and configured into the reader at a time

(i.e. the V-Smart reader shall not support both Standard 26-bit and Northern

34-bit output at the same time depending on the card or user).

*This format is available as a Custom Pre-Defined Format and must be

manually uploaded to the reader. Please refer to section 13.3: Custom Pre-

Defined Formats. Contact Bioscrypt Technical Support to confirm

compatibility with your reader.

13.3. Custom Pre-Defined Formats

The V-Smart reader shall support the use of a Custom Wiegand Format. A slot

on the Pre-Defined Wiegand Formats drop-down list shall be allocated to a

Custom Wiegand Format. A Custom Wiegand Format file shall be required

and must be uploaded onto the V-Smart reader. This file may be created

only by the Bioscrypt Engineering Department after thorough tests are

completed involving all necessary equipment (i.e. cards, Access Control

System, etc.) to be utilized at the site. Please contact Bioscrypt Technical

Support to see if the Wiegand format used by your Access Control System is

available as a custom Wiegand format.

13.4. Pass-Thru Formats

If the format you prefer to use is not available as a Pre-defined or Custom

format, the V-Smart reader shall support a Pass-Thru mode. In this mode,

critical information about the format is provided to the V-Smart reader, which

shall allow the V-Smart reader to correctly generate the card ID required to