Operating instructions

108 FLOWSIC600 · Operating Instructions · 8010125 V 4.0 · © SICK AG
Troubleshooting
Subject to change without notice
6.4 Meter connection troubleshooting
Meter not found at initial connection/connection lost during session
 Check all cables and the hardware. Check also the correct installation of the adapters
(see
 pg. 57, 4.2.1 and  pg. 58, 4.2.2).
 Attempt to re-establish connection via "Connect to Meter" window.
 Use the options in the window displayed to make MEPAFLOW600 CBM search with
wider options (
 Figure 44), especially if parameters (e.g. the baud rate) may have been
changed.
Figure 44 "Meter not found" dialog for the specification of wider search options.
If necessary, the RS485 ports can be assigned to a specific bus address (Reg.
#5020 "DeviceBusaddress"). The service port always has the bus address "1".